Front Washer Motor
| 1. |
With the washer motor connected to the
reservoir tank, fill the reservoir tank with water.
|
Before filling the reservoir tank with
water, check the filter for foreign material or contamination.
if necessary, clean the
filter. | |
| 2. |
Connect positive (+) battery cables to
terminal 1 and negative (-) battery cables to terminal 2
respectively. |
| 3. |
Check that the motor operates normally and the
washer motor runs and water sprays from the front
nozzles. |
| 4. |
If they are abnormal, replace the washer
motor.
No
|
Description
|
No
|
Description
|
1
|
Ground
|
2
|
Windshield washer
(+)
|
|
| -
|
When servicing the washer pump, be
careful not to damage the washer pump
seal. |
| -
|
Do not operate the washer pump before
filling the washer reservoir.
Failure to do so could result in
premature pump
failure. | |
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the front bumper cover.
(Refer to the BD group - "Front
bumper") |
| 3. |
Remove the washer hose (A) and disconnect the
washer motor connector (B).
|
| 4. |
Remove the front washer motor
(A).
|
| 5. |
Remove the rear washer motor (A).
|
| 6. |
Remove the washer reservoir (B) after removing
bolts (A).
|
| 1. |
Reassemble the washer reservoir.
|
Before installing the pump motor, check
the filter for foreign material or contamination. if
necessary, clean the filter into the pump
motor. | |
| 2. |
Connect the washer motor connectors and washer
hoses. |
| 3. |
Install the front and rear washer
motor. |
| 4. |
Install the front and rear washer
nozzle.
Tightening
torque (Bolt) :
3 ~ 5 Nm (0.3 ~ 0.5 kgf.m, 2.2 ~4.2
lbf.ft)
| |
| 5. |
Install the front bumper
cover. | |
